General safety instructions
Act sensibly and logically while using the device
Use a standard computer desk where all the cables pass through the desk itself - do not place the appliance on an unstable cart, stand, or table. The device may fall and cause serious damage
Do not place the appliance near, or above a radiator, heater, air conditioner, or vent
Do not place any object on the power cord
Do not place the device in a position that will expose the power cord to damage by stepping on people or a chair
Do not overload electrical outlets or extension cords. Overload may bounce off the reduction relay and cause a malfunction and/or in a more severe case will cause a fire or electric shock
Disconnect the power cord or computer interface cables from the animal
Do not place the cable where pests such as mice and other barriers that could cause damage to the cable pass. There is a possibility of danger of electric shock or fire
Be sure to lay the cable loose and do not close it using furniture and accessories such as a desk
Care must be taken to connect the product to electrical outlets that comply with the Israeli standard
Before moving the product, disconnect it from an electrical source.
Only a standard electric cable adapted to the Israeli standard should be used
Do not insert any objects into the device through the chassis openings
The objects may touch a dangerous voltage point and create a situation of the danger of fire or electric shock
Do not spill liquid of any kind on or into the device
In case of long-term lack of use, it is recommended to disconnect the product from the power supply and store it closed in a box in order to prevent dust and pests from entering it as much as possible
Do not disassemble the device. When repair is required take the device to a qualified service technician. Opening or removing covers may expose you to dangerous electrical voltage or other hazards. Improper reassembly may result in electric shock the next time the device is used.
Avoid using the device during a lightning storm. There is a possibility of danger of being electrocuted by lightning. If possible, disconnect the power cord from the electrical outlet during a lightning storm
Before cleaning, unplug the appliance. Do not use liquid cleaners or sprays. Use only a damp cloth for cleaning

Safety instructions for laptops
The product must be installed following the installation instructions attached to it
It is advisable not to place the product where there is direct sunlight or near a heat source
Do not install the product in humid or near water areas
Before moving the product. Disconnect it from an electrical power source.
Proper ventilation must be allowed on all sides
Do not insert any objects into the ventilation openings of the product
Do not connect the power cord to a faulty power source
Be sure to use the original power cords provided with the product. Do not use the cable
Alternate without the approval of a qualified service person. Also do not use a torn, cut or damaged electrical cableBe sure to connect the product to standard electrical outlets that provide 220volt \ 50Hz to which the product is adapted
The product ground cable must be connected. If there is one, do not connect the grounding to telephone cables or gas pipes
Do not touch the electrical outlet with wet hands
Before cleaning the product, unplug it
Do not attempt to repair the product yourself 
In case of opening the product, the warranty will be removed
In case of fault contact a qualified service personIn case of long-term lack of use, it is recommended to disconnect the product from the power supply and store it closed in a box in order to prevent dust and pests from entering it as much as possible
Do not use the product in the vicinity of accessories that cause distortions such as magnets, speakers, power line
Electric, transformers and the like
Do not expose the computer to magnetic fields
Do not expose your computer to rain or moisture
Do not spill water or any other liquid on the computer
Do not expose the computer to shocks or vibration
Do not expose your computer to dust or dirt
Do not place any objects on the computer
Do not close the computer screen tightly
Do not place the computer on unbalanced surfaces

Safety instructions for displays
Do not place the device on a rickety surface, stand, tripod, table, etc., place it on a flat and stable surface that can carry its weight
Do not insert any objects through the vents
During a storm (especially lightning), disconnect the screen from the power supply and the antenna
Do not step on or tamper with the power cord
It is recommended that you connect the monitor to a separate outlet to avoid overload
If you do not intend to use the product for a long time, it is recommended to disconnect it from the electrical outlet and store it in a cool, dry place
If there is a remote control, do not drop the remote server or cause it to shake
Do not place wet objects on the screen or the power cordMake sure the monitor is turned off before plugging in
Make sure the power cord and other cables are connected properly and securely
Do not try to open the screen. You can get electrocuted! In the event of a malfunction, contact a qualified service person
Do not expose the screen to direct sunlight or heat
Do not spill liquids on the screen
Do not use the screen when magnetic or electronic products are operating near it
Do not use harsh chemicals or strong solvents to clean the screen. Wipe it with a soft, damp cloth dampened with water
Do not place objects on the screen
Poor ventilation can cause the screen to overheat
Do not touch your fingers directly on the screen. Fingerprints contain grease that can be difficult to clean

Network Equipment Safety Instructions
Do not use equipment in a high-temperature environment such as a hot oven, a place exposed to the sun, etc
Prevent liquid or moisture from entering the equipment 
Do not insert or remove the equipment from the power outlet with wet hands
Do not attempt to open the device in the event of a malfunction and contact a professional service person
When using an extender, make sure that the grounding conductor in the cable is in good condition

Safety instructions for memory cards
Do not remove or insert a memory card or turn off the device while editing the data
Do not touch the metal contacts with your hands or shorten them with metal objects
Do not bend or knock on the memory card. Keep the card away from water and high temperatures
Keep memory cards away from small children
Do not shorten contact points or expose them to liquids or moisture
 When not in use, store it in its original antistatic container
Do not use force when inserting or handling the card, and do not expose it to excessive heat or strong magnetic fields

Safety instructions for peripherals
Read the general safety instructions as well
Do not use a water control device for example in a bathroom, or near a sink, in a damp basement, near a swimming pool, etc
Printers should read the general safety instructions and in addition, if you print many pages in a row, the output tray may overheat. Be careful not to touch the surface and keep children away from the surface
Do not use charcoal or coated paper but plain paper. Other papers may cause a short circuit or fire

Safety instructions for music systems Speakers / Media Streamers
Do not use a water control device, for example in a bathroom, or near a sink, in a damp basement, near a swimming pool, etc
Use only stands or carts recommended by the manufacturer that complies with the Israeli standard
Check that the manner in which the device is placed and positioned will ensure proper ventilation. For example, do not lay on a bed, sofa, rug or any similar surface that may block the vents. The device must not be placed in a bookcase or cabinet where there is no possibility of air flowing through the vents
The device should be placed away from heat sources such as radiators, heat spreaders, heaters, other heat dissipating devices including amplifiers
Only connect the device to a power source of the type described in the operating instructions or listed on the device itself
Precautions should be taken not to damage the grounding device of the device
The power cables must be installed in such a way as to ensure that they are not stepped on and that there is no object to crush them
Particular attention should be paid to the connection points of the devices
Before cleaning, unplug the appliance. It is usually possible to make do with cleaning with a dry cloth. Do not use other preparations
Do not install an external antenna near power lines
If the appliance is not used for a long time, it must be disconnected from the power supply
Care must be taken not to drop objects or spill liquids through the openings of the device
If you notice an unusual odor or smoke emitted from the appliance, unplug it immediately and contact a professional service person